What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
14.06.2025 13:19

Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
The MOV will conduct when the voltage exceeds 50% of line voltage.
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
What is the reason behind the Russian government's negative view on foreign travel?
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
The third is lightning and “how it gets conducted into a home.”
Upvotes:
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
These are simplified answers to the original question, and does not change anything I wrote above.
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
The other is “what does a “fuse” do?”
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
It also is a device that limits the change in current flow.
So, the voltage could go up to 500 volts, and the fuse will not open up.
the problem then depends on "how fast does the fuse operate?".
If there was only one man remaining on the Earth, would this be regarded as extinction?
He then asserts :
This is where this question deviates from being a 'generic' question, and becomes more specific.
eight
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
2024–10–10[John johnson John Johnson ]
Now when you have a certain ac resistance, then a current flows in a loop.
Have you ever witnessed political correctness harm someone?
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
This is where the MOV conducts again, and dissipated the energy.
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
If you received hand-me-downs as a child, how did they make you feel?
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
What is lightning?
One
Why are white women so hard to date?
At least they know the answer if they wanted it.
Barnstars:
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
Why do some people believe that Homelander would be no match for Superman or Thor?
This device then solves the entire problem.
There are three different concepts here that are getting confused.
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
What is your craziest/worst Halloween story?
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
Can you write a letter to your first love without mentioning his/her name?
One is “what exactly is in a ‘surge protector’ ? ”
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
Because the load is inductive, the current lags the voltage.(by a bit).
What did Chandrashekhar Azad say about Hinduism during a podcast?
nine
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
a photo is worth a thousand words.
Why do wives cheat with black guys?
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
What does a fuse do?
But… the neutral is now “floating” because of the 1 ohm resistance.
At one ohm, the resistor has a maximum of 1 watt power.
A circuit breaker is similar, but is resettable.
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
The bolt then partially travels down the line to your home.
But it can get overloaded, and no longer works.
This one hit behind the barn.
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
It seems Mohan does not understand the difference between a comment and an Answer.
[old diagram got deleted by accident]
2024–10–16 [ OO OLAOYE OYEBODE ]
what exactly is a ‘surge’ protector?
An AC voltage/ current source, and an ac inductive load.
Can the fuse protect the electronic devices from lightning instead of a surge protector.
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
2024–10–14 [Omar Gharbi Omar Gharbi ]
but I think this circuit , shows a few more pieces.
Here is a simplified AC power diagram.
This is 'the assistant's answer'
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
These devices are installed between the “hot” and “neutral” and protective ground.
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
First Sentence:
but this device (an Inductor) … impedes the rapid changes in the current.
He then describes the function of a fuse.
so, what happens?
I post the exact comment here.
Edit 2024–10.
In schematic diagrams this is the symbol for a fuse:
He then describes Rainy Season and Lightning.
(Dc diagram shown, AC is similar).
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
There are two important concepts here.
For this case there are devices called Metal oxide varistors (MOV).
[image of Common-mode choke]
This is the picture of an electronic coil of wire wound around a core of magnetic material.
A fuse is a non-resetable over current circuit protector.